What would cause this? - Bambu Lab X1-Carbon - Bambu Lab Community Forum

The original hot end ended up getting bent (don’t know how, but it did). I replaced it with the included replacement. I did a calibration and everything looked fine. I went to print a simple model on extra fine 0.08mm on the BBL textured PEI plate (as see in the pic) with Overture PETG. As you can see, the nozzle tip gouged the plate and broke off and ended up bending the hot end. What would have caused this to happen? Did I miss a step in the installation of the replacement hot end? Is t

Problems with axes, and it does not respond to the signals that I

Bambu Labs X1 Carbon

Bambu Labs Printers, [H]ard

Bad service , bad technicians … - Bambu Lab X1 Series - Bambu Lab

Creality K1 Max vs QIDI X Max 3 vs Bambu X1

Bambu Lab P1S Review: A New Standard for 3D Printing

Bambu Lab (@BambulabGlobal) / X

Dust Cover for Bambu Lab X1-carbon

3D Printer Review: Bambu X1 Carbon with AMS - Make

Bambu Lab X1 Carbon with AMS Review - 3DGearZone

CNX-Software] - Bambu Lab X1 – A color 3D Printer with LIDAR and

The Best 3D Printers in 2023 – Buyer's Guide

AMS results for Bambu Lab X1-Carbon - FDM 3D Printers

Prusa MK3S+ vs Bambu Lab X1 carbon - Page 10 – General discussion